Why you shouldn't use EDTA based Desulphator additives?

• EDTA usually comes in powder form, or as a solution. With manufacturers tending to favour sealed maintenance-free type batteries, there is no chance to introduce EDTA to the battery in the first place.
• EDTA works by forming a complex compound with the lead sulfate layer on the plates. While this removes the insulating layer, the active material that had formed lead sulfate will not be reconverted once the battery is charged. In principle, the insulating layer of lead sulfate is removed; but active material, needed for an efficient battery, is sacrificed in the process.

EDTA reacts with the lead sulfate to form the complex compound above. The plates are cleaned, but active material is not returned to the battery.

Complex compound formed by breaking the lead sulfate bond.

Battery life is ony extended temporarily with the removal of the lead sulfate crystals and increase of reaction surface area, but the lifespan of the battery cannot be maximized where active material is not returned to the battery.

Our Battery Desulfators however, use a different process which generates Amplitude Modulated Pulses at the resonance frequency of the crystals to shatter the covalent bonds that hold it together. This allows the lead sulfate to be reconverted once the battery is charged. A battery free from lead sulfate crystals will have its lifespan stretched to its maximum! No more premature failure due to sulfation!

Why buy our desulphators over battery additives? 

• A reusable technology, made to last and to be reused over and over again - you'll only need to buy it once.
• A better technology, a true life span optimization and not a temporal one.
• Its cheaper to buy with no maintenance needed.
• Its easier to use - simply install it and you're done!
• Its safer, no contact with caustic chemicals.